Jive Knowledge Base : Can I get video from multiple sources to scroll across several monitors sequentially using the VEEMUX Video Matrix Switch?

Knowledge Base Home » VEEMUX - Video Matrix Switches » Troubleshooting » Document 129

[129] Can I get video from multiple sources to scroll across several monitors sequentially using the VEEMUX Video Matrix Switch?

« Back to Category

Author:	Administrator, Created on: Aug 30, 2007 9:04 AM
Language:	English

Printer Friendly

Can I get video from multiple sources to scroll across several LCD monitors sequentially using the VEEMUX Video Matrix Switch?

Yes, use the scan mode of the VEEMUX Video Matrix Switch to have an output port automatically switch from one input port to the next consecutive input port after a specified period of time (referred to as the dwell time). The dwell time can be set from 0 seconds to 32000 seconds.

To have video from multiple sources scroll across different monitors, follow the steps below:

From the left bar menu of the Web Interface, select "Administration" and then "Outputs Scanning Sequences". Set the time for each output but do not enable the scan mode at this time; All the timings should be set to the same value.
From the Web Interface, access the "Switch Page" and set all the sources to the starting position and press the "Submit" button.
On the "Switch Page" check the "Sequence Enabled" boxes corresponding to the output ports being used and press the "Submit" button.

The computers will then be scanned in ascending order (with roll over).

Comments

No comments.

Welcome, Guest

Guest Settings


	Welcome