Jive Knowledge Base : How do I set up the SERIMUX-SCRP-x Console Switch to run the Windows Server 2003 SAC?

Knowledge Base Home » SERIMUX-Console Switches » FAQ » Document 142

[142] How do I set up the SERIMUX-SCRP-x Console Switch to run the Windows Server 2003 SAC?

« Back to Category

Author:	Administrator, Created on: May 6, 2008 11:51 AM
Keywords:	SERIMUX console switch set up windows server 2003
Language:	English

Printer Friendly

How do I set up the SERIMUX-SCRP-x Console Switch to run the Windows Server 2003 SAC?

1. Configure the BIOS for console port redirection to a COM port

2. Set up the Windows Server 2003 for SAC support

Log in to the server as Administrator
Access the command line
Use the bootcfg command to redirect the console to a COM port

Command Syntax:

Example:

3. Set up the SERIMUX-SCRP-x for SAC Support

Access the SERIMUX-SCRP-x Web Interface
Select ? Serial Port ? and then ? Configuration ?
Select the port to configure
Select ?Host Mode Configuration ?
From the Host Mode pull down menu select ? Console server ?
From the Type of Console Server pull down menu select ? MS SAC Console ?
Select "Save & Apply " at the bottom of the page
From the menu select ? Serial Port Parameters ?
Enter the baud rate, data bit, and parity to match the COM port settings
Set Flow control to None and ignore the DTR settings
Select "Save & Apply " at the bottom of the page

Comments

No comments.

Welcome, Guest

Guest Settings


	Welcome