Use the form below to enter your search criteria. By default, all content is searched except for document comments. If you wish to search comments as well as everything else, click "Also Search Comments" below.
[1833]
Comments: 0,
Last Modified: Feb 7, 2018 11:18 AM
- Find Similar
E-SDS or E-SDS-CE: How can I tell if my smoke detection sensor is working? The smokedetector can be tested by using canned smoke or burning a small piece of cotton near the sensor while it is powered ... sound after the pre-configured alert delay time has elapsed. To reset the sensor, wait till the smoke ... residue smoke in the sensor; wait a while before power cycling the sensor again. Acknowledge
[2034]
Comments: 0,
Last Modified: Feb 7, 2018 10:28 AM
- Find Similar
-SDS or E-SDS-CE: How can I tell if my smoke detection sensor is working? The smokedetector can be tested by using canned smoke or burning a small piece of cotton ... ;s LEDs should be on “Red” continuously. To reset the sensor, wait till the smoke has ... residue smoke in the sensor; wait a while before power cycling the sensor again. Acknowledge
[132]
Comments: 0,
Last Modified: Feb 7, 2018 10:52 AM
- Find Similar
How can I tell if my smoke detection sensor is working? You can test the smoke detection sensor using any strong magnet such as a used hard drive magnet or a door contact switch magnet. To do so: Power the sensor on. The sensor's LEDs flash "Green" when the sensor is on. Hold the magnet directly under the word "TEST" on the sensor. If the sensor is functioning properly
[133]
Comments: 1,
Last Modified: Feb 7, 2018 11:27 AM
- Find Similar
to wire this smoke/fire detector to operate as a normally closed sensor as opposed to normally ... How can I tell if my smoke detection sensor is working? You can test the smoke detection sensor using any strong magnet such as a used hard drive magnet or a door contact switch magnet. To do so: Power the sensor on. The sensor's LEDs flash "Green" when the sensor is on. Hold the magnet
